Address: The southern end of Luhai Road, Binhai Development Zone, Weifang, Shandong Province
Contact: Chen Jintuan
Phone:13905360309
Tel:0536-5333577
PC:262737
Web:www.wfjintan.cn 收割机刀片.中国 金坛刀片.中国
E-mail:lily@wfjintan.cn sgjintandp@163.com
Copyright © 2020 Weifang Haihua Development Zone Jintan Harvester Blade Factory Copyright
Scan the QR code
Weifang Haihua Development Zone Jintan Harvester Blade Factory
Weifang Haihua Development Zone Jintan Harvester Blade Factory is located at the southern end of Luhai Road in Binhai Development Zone. The company was established in 2001 and has modern plants and equipment.
(Lower teeth) Harvester Blade manufacturers teach you how to troubleshoot harvesters
(Lower teeth) Harvester Blade manufacturers tell you that every harvest season, harvesters are absolutely indispensable in the farmland. Nowadays, I don’t need to talk about the role of harvesters. I don’t need to say more about the role of harvesters. You may encounter some failures, the following (Lower teeth) Harvester Blade manufacturers will teach you how to troubleshoot:
1. (Lower teeth) Harvester Blade manufacturer tells you that if the normal operation encounters severe engine vibration, the driver should immediately stop the operation, drive the car into an open area, and after getting off the car, first or tighten the cross bearing of the car's drive shaft. Check if the fixing bolts are loose. When it is determined that the cross bearing is damaged, replace the new parts. If the tightening bolts are loose, use a torque wrench to tighten the bolts.
2. (Lower teeth) Harvester Blade manufacturer tells you that if the chopper spindle temperature is high during operation, the driver should stop the operation and get off the car to check whether it is caused by oil shortage or the V-belt is too tight. Inject oil; (Lower teeth) Harvester Blade manufacturer tells you that if the V-belt is too tight, you should immediately adjust the tightness of the reel.
3. (Lower teeth) Harvester Blade manufacturer tells you that if you hear noise from the gearbox during normal operation, you should stop the operation, get out of the car and check whether the gear backlash is inappropriate, and when the gear or bearing is damaged, you should adjust the backlash to 0.15~0.35mm or replace the bearing to run.