Copyright © 2020 Weifang Haihua Development Zone Jintan Harvester Blade Factory Copyright
Scan the QR code
Weifang Haihua Development Zone Jintan Harvester Blade Factory
Weifang Haihua Development Zone Jintan Harvester Blade Factory is located at the southern end of Luhai Road in Binhai Development Zone. The company was established in 2001 and has modern plants and equipment.
155 Harvester Blade manufacturer takes you to know: Tips for maintenance of harvester blades
1.155 Harvester Blade manufacturer tells you to strictly follow the lubrication chart in the combine harvester manual, the lubrication part of the table, the cycle time and the oil type to carry out the lubrication.
2.155 The Harvester Blade manufacturer tells you to check every component connection and tighten it immediately if there is any looseness. In particular, check the blades of the crushing device, tighten the scraper conveyor, and see if the panel is deformed or damaged.
3.155 The Harvester Blade manufacturer tells you to clean the cutter. After cleaning, wipe the surface of the cutter with anti-rust agent to prevent the cutter from being rusted.
4. Remove the cutter assembly, the manufacturer of 155 Harvester Blade tells you to apply rust inhibitor to the horizontal board after cleaning, or hang it to avoid deformation.
5.155 Harvester Blade manufacturer tells you to clean the sprocket and apply rust inhibitor on the surface of the sprocket to avoid rust. In addition, lubrication is carried out on each contact moving part of the sprocket.
6.155 The manufacturer of Harvester Blade tells you that for a new or newly repaired combine harvester, all the oil in the gearbox should be drained after the test run, and new oil should be added after it is cleaned and tidy. The manufacturer of 155 Harvester Blade tells you to check the oil level once a week at work, and add it immediately when it is lacking.