Address: The southern end of Luhai Road, Binhai Development Zone, Weifang, Shandong Province
Contact: Chen Jintuan
Phone:13905360309
Tel:0536-5333577
PC:262737
Web:www.wfjintan.cn 收割机刀片.中国 金坛刀片.中国
E-mail:lily@wfjintan.cn sgjintandp@163.com
Copyright © 2020 Weifang Haihua Development Zone Jintan Harvester Blade Factory Copyright
Scan the QR code
Weifang Haihua Development Zone Jintan Harvester Blade Factory
Weifang Haihua Development Zone Jintan Harvester Blade Factory is located at the southern end of Luhai Road in Binhai Development Zone. The company was established in 2001 and has modern plants and equipment.
155 Harvester Blade manufacturer takes you to understand: how to deal with cooling system failure
1.155 Harvester Blade manufacturer's overloaded work harvester consumes too much power when operating for a long time, which easily causes the engine speed to drop, the fan speed to reduce, and the air volume is insufficient, which causes the engine to overheat. Remedy: 155 Harvester Blade manufacturers try to work in drier fields first, and adjust the forward gear, cutting width and stubble height of the harvester in time according to crop yield, height, and maturity. Minimize long-term overload work.
2. The method of adding cooling water is wrong. Some operators of 155 Harvester Blade manufacturers often wet the heat sink when adding cooling water. What's more, they pour excess cooling water to the radiator. Doing so will make it easier for dust to stick to it and cause blockage, reducing the heat dissipation effect. Remedy: When adding cooling water, try not to wet the radiator, let alone pour water on it. The operator should correct this incorrect operation method.
3. If the water tank is not covered, the heat dissipation core tube is blocked; many operators of 155 Harvester Blade manufacturers like to leave the water tank open to work, so that when the water temperature is too high, open the engine cover to add water. In this way, crop leaves and dust easily enter the inside of the water tank, and the cooling water reaches the body and cylinder head and gradually deposits, which affects heat dissipation. In severe cases, it can also cause blockage of the heat dissipation core tube and cause the engine to overheat. Elimination method: In order to save the cooling time required for adding cooling water, the water tank can be sealed with multi-layer gauze after being opened, and fixed with lead wire to prevent crop leaf and dust from entering the water tank.
4. The radiator is not well maintained. During the working process of the 155 Harvester Blade manufacturer's harvester, it is easy to produce blockages in the lower air passage of the radiator. You should always pay attention to the maintenance of the radiator. However, in some places, there is a lack of air pump and water gun equipment, and the operator often ignores this aspect of work. With the increase of time, the blockage of the heat dissipation surface becomes more and more serious, and even the heat dissipation function is lost. Elimination method: timely remove the blockage on the air passage between the radiator fins. 155 Harvester Blade manufacturers can generally use compressed air to remove. When it is difficult, it can be rinsed with a water gun, and combined with a fine iron wire to dredge. But after flushing, the radiator must be dried before it can be put into use.
5. The method of adding cooling water is incorrect. Some operators of 155 Harvester Blade manufacturers often wet the radiator fins when adding cooling water. What is more, they pour excess cooling water to the radiator. The 155 Harvester Blade manufacturer will make it easier for dust to stick to it and cause blockage, reducing the heat dissipation effect. Remedy: When adding cooling water, try not to wet the radiator, let alone pour water on it. The operator should correct this incorrect operation method.