Address: The southern end of Luhai Road, Binhai Development Zone, Weifang, Shandong Province
Contact: Chen Jintuan
Phone:13905360309
Tel:0536-5333577
PC:262737
Web:www.wfjintan.cn 收割机刀片.中国 金坛刀片.中国
E-mail:lily@wfjintan.cn sgjintandp@163.com
Copyright © 2020 Weifang Haihua Development Zone Jintan Harvester Blade Factory Copyright
Scan the QR code
Weifang Haihua Development Zone Jintan Harvester Blade Factory
Weifang Haihua Development Zone Jintan Harvester Blade Factory is located at the southern end of Luhai Road in Binhai Development Zone. The company was established in 2001 and has modern plants and equipment.
688Harvester Blade manufacturer teaches you: how to judge the failure of the harvester
The 688Harvester Blade manufacturer tells you that every harvest season, harvesters are absolutely indispensable in the farmland. Nowadays, I don’t need to talk about the role of harvesters. I don’t need to say more about the role of harvesters. Harvesters have a lot of work during busy periods, and they are very likely to encounter For some failures, the following 688Harvester Blade manufacturer will teach you how to troubleshoot:
1. The manufacturer of 688Harvester Blade blade tells you that if the normal operation encounters severe engine vibration, the driver should immediately stop the operation and drive the car to an open area. After getting off the car, first loosen the cross bearing or fastening bolt of the car's drive shaft. Check and confirm that when the cross bearing is damaged, new parts should be replaced. If the tightening bolts are loose, the bolts can be tightened with a torque wrench to work.
2. The manufacturer of the 688Harvester Blade blade tells you that if the chopper spindle temperature is high during operation, the driver should stop the operation and get off the car to check whether it is caused by oil shortage or the V-belt is too tight. After inspection, the oil should be filled with oil; If the V-belt is too tight, adjust the tightness of the reel chain immediately.
3. The manufacturer of 688Harvester Blade blade tells you that if you hear noise from the gearbox during normal operation, you should stop the operation and get off the car to check if the gear backlash is not appropriate. When the gear or bearing is damaged, the backlash should be adjusted to 0.15~0.35. Mm or replace the bearing to run.