Copyright © 2020 Weifang Haihua Development Zone Jintan Harvester Blade Factory Copyright
Scan the QR code
Weifang Haihua Development Zone Jintan Harvester Blade Factory
Weifang Haihua Development Zone Jintan Harvester Blade Factory is located at the southern end of Luhai Road in Binhai Development Zone. The company was established in 2001 and has modern plants and equipment.
Harvester Blade (hay knife) manufacturers teach you the troubleshooting "skills" of harvester
The Harvester Blade (hay knife) manufacturer tells you that during the wheat harvest season, the worry is that there is a problem with the harvester. The Harvester Blade (hay knife) manufacturer tells you that you will inevitably encounter some mechanical failures in your work. You only need to grasp the method of troubleshooting, and it is still possible to deal with some short-term problems.
1. There are many straws
The Harvester Blade (hay knife) manufacturer tells you that the wheat has high maturity, the weather is dry, and the straw is over-dried; the threshing component tile has a large sieve opening. elimination method:
① Reduce the gap between the threshing tiles and the screen, the upper sieve opening should not exceed 2/3, and the lower sieve opening should generally not be less than 1/3.
②When the harvester reaches the ground, the header will be raised quickly, and the large throttle will send the remaining wheat in the trough.
2. The ears are not clean
The manufacturer of Harvester Blade (hay knife) tells you that there are many green heads of wheat ears; the threshing gap between the stalk of the threshing part and the concave plate is too large, and the rotation speed is low. elimination method:
① Control the cutting width of the field, within 2/3;
②Adjust the threshing gap of the thresher, reduce the rotation speed of the drum, and expand the gap of the concave plate. Obviously worn parts should be replaced immediately.
③Tighten the tyre belt of the threshing unit with the power machine.