29
2021
-
10
The Harvester Blade Guard manufacturer teaches you how to deal with failures during the operation of the harvester
Author:
The Harvester Blade Guard manufacturer tells you friends who often drive harvesters should know that it is inevitable that the harvester often fails during operation.
The Harvester Blade Guard manufacturer tells you friends who often drive harvesters should know that it is inevitable that the harvester often fails during operation. The harvester blade, the harvester blade and the header are the most prone to failure accessories.
The Harvester Blade Guard manufacturer tells you that harvester blades are often easily damaged. They encounter hard objects such as rocks and tree roots during the cutting process; the blade guard is loose or deformed, which makes the fixed blade inconsistent; the blade rivet is loose and the cutting time is phased. Touching, etc. may cause damage to the cutting blade. The Harvester Blade Guard manufacturer tells you that in order to prevent damage to the blade, you should pay attention to the obstacles in front of the cutter during operation to prevent the blade from cutting hard objects such as iron wires or colliding with stones, telephone poles, wooden posts, etc. During maintenance, always check and adjust the blade guard so that the fixed blade is in the same horizontal plane, and the loose blade should be riveted in time.
The manufacturer of Harvester Blade Guard tells you that the common fault of the cutter bar of the harvester is the break of the cutter bar, mainly because the cutter movement resistance is too large or the installation position of the cutter drive mechanism is incorrect. In order to prevent the knife bar from breaking, the cutter should be adjusted correctly to reduce the movement resistance of the cutter, and at the same time, adjust the installation position of the cutter drive mechanism to meet the assembly requirements. After the knife bar is broken, the spare cutter should be replaced and the broken knife bar should be repaired. After the wheat is harvested, the unloaded cutter should be placed on the flat frame in the warehouse or hung vertically on the beam in the warehouse to avoid bending and deformation of the cutter bar.
The Harvester Blade Guard manufacturer tells you that the most common problem with the harvester header is the slip of the auger. The gap between the auger's spiral blade and the bottom of the header is too large, especially when harvesting dwarf wheat. The cut crops cannot be grasped, cannot be transported in time, piled up and blocked in front of the auger, causing the header auger to slip. The Harvester Blade Guard manufacturer tells you that in order to prevent this failure, you should correctly adjust the gap between the spiral blade and the header box according to the density and height of the crop; when the edge of the blade is polished, the pushing efficiency will be reduced. , Use a flat spatula or file to process small teeth to improve its grasping and pushing capabilities.
Low,price,Harvester,Blade,Guard,Harvester,Blade,Guard,supplier(s),china
Related products
/ PROJECT
Weifang Haihua Development Zone Jintan Harvester Blade Factory
Address: South end of Luhai Road, Weifang Binhai Development Zone, Shandong Province
Mobile website
Copyright © 2022 Weifang Haihua Development Zone Jintan Harvester Blade Factory